Calculating the gap between the pivot hole and the centre of the dome, the pivot hole itself, and the gap between the pivot hole and the dome edge, the dome edge seems to measure 530 in diameter.   And yet, the overall measurements for the length of the dome edge were 460 in the plans.   Am I reading this correctly?   I saw that there was a previous thread on 'NSD Dome Detailing Dimensions Making No Sense', which suggested all measurements were measured directly from an actual, physical curvy NSD dome. So, I attempted to measure it according to the curve using 'edge length' on blender. However, this still causes the pivot hole to push out of the conical section.   Am I doing anything wrong?   Thanks

This morning I ripped the fender timber on my bandsaw. I'd had to postpone doing this job, as one of the blade roller guides in the bandsaw had come loose, and I needed a replacement part to arrive. First thing, I scaled up and sketched the dimensions of the fender, plus its approximate position in relation to the skirt wall and drill hole positions.   As I am cutting a hardwood, it is critical that the bandsaw is set up properly to achieve nice, true cuts. I spent a fair bit of time setting up the bandsaw, adjusting the blade tension, setting the bearings correctly etc. Even so, I was a touch apprehensive when I started... however, my concerns were unfounded, as the bandsaw performed excellently, cutting all 42 pieces without a hitch.   For some of the longer pieces, I would cut halfway down the length, then flip the piece over and do the rest from the opposite side. It was always very pleasing to see the bandsaw cut accurately hit the previous cut square-on at the halfway point! Of course, as these are to be glued together, I need nice flat pieces of wood!   I thought I'd specified excess width on my beechwood timber order, so would need to rip the top and bottom pieces seperately, but as it turned out the supplied wood was exactly the right dimension to get both segment sections in a single cut. So bad measuring on my part, but lucky! I'll start gluing it all tomorrow.

Other option is to go full size cardboard Dalek - as I don't think this chair can carry more weight than that.   A wood/board frame skinned in cardboard, papier mache hemis?   I already have a papier mache dome.   Perhaps non functional arms?      

Evening all!   Both alot and not much has happened over the last 2 days.   I had a print detach from the bed and cause the blob of death on one of my printers. So this evening was spent replacing the damaged parts.   3 pieces have come off printers since. The resin experiment was a failure. The heated chamber did little to counter the strange warping effects. I will try a different resin at some stage and see if that has any effect!   I reprinted the final piece in the last post and did the followup piece.   Now with both printers back in action, they're churning out the next 2 pieces.   We're officially halfway on level 1.     I will decide when I get to the end of the first level if I will re-do piece 3 that's still resin. We will see.