Hi, I bought them to make an eye and you only need a few cm off the tubes so I'd like to sell the rest of it to someone so they dont have to pay the 60 the full tubes cost. I want about 15 pounds for them but its negotiable. Nottingham billborough area collection only ty.

Another fine and sunny weekend, so a little bit more progress with Dalek Norvic. I cut out of 18mm plywood the circle that will hold my dome Eyestalk, put a 15mm bevel on it, so as not to catch the inside angle of the dome, then I primed the neck and shoulders.

Hi. Thanks for the suggestion. Yes Ive been through the guide and been through a process of elimination. I have an analog joystick somewhere so I was going to solder some wires on and try it (I might still do that), but proving the motor driver side is OK isnt really going to help me if the controller wont link to the receiver. The whole point of using the R/C and linking to the Sabretooth was so that I could avoid wires going into the head, so a controller that wont link is useless to me.

Thanks for te suggestion. That was my original intention (and I may still do this) but Ive already used some araldite to hold the tubes in place, plus there is only a very small aperture to get anything into the balls. I think Ive a can of (old) resin (for fibreglass) in the garage so if its not gone hard in the can I will use that up.